openOccluform-3 Attachment (For Erkoform 3, 3d, 3d+ & 3d Motion)
openOccluform-3 Attachment (For Erkoform 3, 3d, 3d+ & 3d Motion) - Image 2
openOccluform-3 Attachment (For Erkoform 3, 3d, 3d+ & 3d Motion) - Image 3
openOccluform-3 Attachment (For Erkoform 3, 3d, 3d+ & 3d Motion) - Image 4
openOccluform-3 Attachment (For Erkoform 3, 3d, 3d+ & 3d Motion) - Image 5
openOccluform-3 Attachment (For Erkoform 3, 3d, 3d+ & 3d Motion) - Image 6

Occluform-3 Attachment (For Erkoform 3, 3d, 3d+ & 3d Motion)

Occludator capable of being integrated onto all the Erkoform-3 series units to allow imprinting of the opposing bite at the same time as the thermoforming process

The Occluform-3 can only be installed on Erkoform-3/3d/3d+ and Motion units.
The opposing bite is imprinted directly during the thermoforming process.
Metal construction with hydraulic fixation.
Ready for self-installation.

Add to WishlistRemove from Wishlist
Add to Wishlist
Share
Categories,

    The Occluform-3 allows for directly imprinting the opposing bite in the Erkoform 3 series units during the thermoforming process

    The Occluform-3 can only be installed at the Erkoform 3 series units. The construction of the Occluform-3 unit is based on a Bonwill triangle with side length of 11.5 cm and a Balkwill angle of 20°.

    The dimensions of the Occluform-3 allow for a bite elevation at average values. The elevation of 1 line at the supporting pin corresponds to approx. 1 mm bite elevation at the incisal point.
    If a construction bite is produced the models are articulated in the Occluform-3 using this record.

    Reviews

    There are no reviews yet.

    Be the first to review “Occluform-3 Attachment (For Erkoform 3, 3d, 3d+ & 3d Motion)”

    Your email address will not be published. Required fields are marked *

Related Products

e1.jpg00

Erkopress motion – Automatic Thermofoming Pressure Unit
Insert the foil - ...
Add to Cart
Add to WishlistRemove from Wishlist
Add to Wishlist